create counter

Panhard crankcase oil circulation faults (revisited)

A quick history lesson on Panhard engine failures. The front main bearing and front cylinder crankshaft big end started to develop failures, as they increased the horsepower. It was attributed to insufficient oil supply, and so the front end lubrication was revised, and the camshaft timing gears were used as a splash lubrication system and the oil drilling that provided that role under the front main bearing was removed. This modification was introduced from around the early 1960’s, and ran to the end of production in 1967.

This engine is the later type, so needs modifying back to the original oil supply route, but adding the improvements necessary to negate the other faults. The first area to tackle is the front end crankshaft oil supply, so plugging the newer oil drillings and creating a matched new one under the front main bearing housing. These will be fixed with Loctite once all the drilling has finished and the crankcase has been thoroughly cleaned.

Panhard_M10_front_oil_supply

Panhard_M10_front_oil_feed

Plugging the timing gear lubrication drilling, so restoring equal phasing, but fitting a new design of oil light piston to replace this function.

Panhard_timing_gear_drilling

Later I will reduce the oil flow in the timing gear casing, so reduce pump losses, and oil degradation. On examination the deposits in the slingers at the front part of the crankshaft are almost double those at the rear, which is due to the oil supply being much greater and the timing gear casing is a residue trap, because it cannot drain away and be refreshed.